Subnostr

what are the other options tolerance and how much of it is based on materials and types of fabrication? and whats your go to design sw? i'm only familiar with solidworks - gives as much headache as photoshop lol. what's the easiest one ? and a free one ? whats the typical tolerance adjustments you see between 3D and injection moulds? mechanical engineering is interesting but tough.

Jeremiah Baker 2y ago

GD&T works with most types of fabrication from machining to sheet metal. It gives tolerancing that is better able to produce a good part.

Your tolerancing should be done to the widest tolerances possible. It helps with fabrication and cost. So you determine your critical geometry and that should be your tighter tolerance.

Nowadays, I don’t really have a favorite design software. I have used solidworks, creo, fusion 360, and onshape. Onshape was inexpensive and probably the easiest. Fusion I believe is still free for “enthusiasts”.

I’m not sure what you mean by tolerance adjustments on the moulds? Not sure if you mean material expansion or part tolerancing?

Mechanical engineering requires quite a bit of practice and continuous learning. Just takes time. You have to gain a sense for it.

Thank you for the questions! I am here to help!

Reply to this note

Please Login to reply.

Discussion

pam 2y ago

Thanks! i work with product designers mostly but its a struggle replicating between 3D precision and injection mould's high tolerance.

Jeremiah Baker 2y ago

I haven’t had the opportunity to work with injection moulds. What kind of precision range are you working with?