Replying to Avatar Scott

Any trouble with warping?
Avatar
BtcPins 2y ago

The case? Nope. It's PETG I think so it should hold up fine.

Reply to this note

Please Login to reply.

Discussion

Avatar
Scott 2y ago

I mean during printing. Is your printer setup in an enclosure? I have had trouble with warping at the base on the corners for larger prints. Working on enclosure setup to see if that helps.

Avatar
BtcPins 2y ago

No I get pretty good bed adhesion.

Avatar
BtcPins 2y ago

No enclosure.

I print 1st layer at 65° bed, 200 extruder, 0.2 height. Then 60/195/0.15 after.

On a PEI sheet on the print bed.

Avatar
Scott 2y ago

You're printing PETG at 200 degrees?

Avatar
BtcPins 2y ago

No. PLA. I haven't printed with PETG.

Bought the case printed from CryptoCloaks