3d printing is easier than you think.
Did you know that you can pick these up on FB marketplace for $100-150?
For those who want to “mass produce “. Use Linux and Klipper software to speed up the printing times.
There’s an entire community ready to help you too.
#grownostr #tsp #3Dprinting
I'll need to look into Klipper. Been using a RaspberryPi 3 to control things over the network. Thanks for the post.
Klipper takes a three hour print down to like 20 minutes. You will want to run your nozzle hotter to compensate, but then you might need a fan to cool the print so it doesn’t run/drip. When you get everything tweaked, it’s amazing. You watch it print at “super speed” and think you are watching a video that has been sped up. Klipper also gives you MUCH more control over your printer than you get on the control module. We run it from Linux on an old laptop, but I’m told it can be on on a Raspberry PI also. I’d like to get my hands on a couple of Raspberry PIs. I need a 3 and a 4 for a couple of projects, but I’m not willing to pay $80 for a version 3 and I can’t even find a 4.
Got me a Bambu lab p1p and I sold all my others after I figure out 20 minutes on benchy where the others took 2 1/2 hours
