Assembly went well. A bit tricky without glue dot for camera. Small flathead screwdriver helped get that set. When I plug in power via usb-c, the screen lights up but no UI. (Even after a few minutes)
Any suggestions for that?
Discussion
There is adhesive on the back of the camera that you can expose by removing a film, sorry for the confusion there. Did you download our software, write it to the memory card, and install the card in the signer like the instructions direct? Without the mem card the device is like a computer without a hard drive, so it won't boot.
That makes sense. Appreciate the clarification. Still need to download the software and write to the memory card then! Assembly was a bit rush on my part. I'll get that done and should be good to go!