Rockstar Figure on Makerworld
https://makerworld.com/de/models/1653831-rockstar-developer-figure#profileId-1748848
Rockstar Figure on Printables
https://www.printables.com/model/1369600-rockstar-developer-figure
Discussion
Printing one of these at 6.15" tall
Had a bit of a failure as nearly halfway through, the poop bin I had filled up. This led to pieces sticking and preventing the head on X axis from getting fully left to the point that I created a mid print offset. I cleared the issue and let it complete just for fun.
Next one I will print in a single color as the filament waste is quite high on color switching
Rockstar was caught red handed here. Unfortunate but I've had this happen before with other prints. These errors and the obvious reduction in time and especially waste was what made me go full toolchanger and get the XL, but I understand it's not for everyone.
The bits which printed look good though.
If you print single color you can get away with very little tree supports too.