Playing with layer height. Seeing how far I can get before I just fuck everything up. Orange was 0.2mm and yellow was at 0.1mm. You can really tell on the tops where the slopes are very low angle. 
Discussion
For reference, orange sliced at 240 layers, yellow sliced at 399 🤯 Added about 1 hour to the print.
That's how ratios work! Cool to see though. What's the boat for?
Nice. Yellow seems to have a tad more stringing though, no? Did you change any other settings, other than layer height?
You’re right, and I think it’s actually the filament, because a separate yellow print with the regular settings I used looked more stringy than usual as well. I’m probably gonna do some more tests more controlled to see for sure though.
Had the same issue when I switched to a new brand of PLA. The stringing is minute, but still noticeable. (Check your DMs, btw.)