Major upgrade on the bitcoin space heater. I've replaced the three aircooled single board #S9 miners with a single board water cooled #S19 that runs cool and quiet while pumping out the heat. Used two Alphacool ES 280mm radiators, four Noctua NF14 1500rpm fans, three noctua 60x25mm fans, and an Alphacool
Eisstation pump and resevior combo. This setup keeps the hashboard under 60c up to 850 watts.
#plebminer #mining #homemining #decentralization #bitcoin #heater #braiinsos
how much would one cost? just curious.
....could a idiot pleb with some construction experience tackle this? Was it difficult to program? Again...I am an idiot
I'll also add that a separate enclosure like I built is completely unnecessary unless like me, you plan on putting it in the bedroom you share with your wife. You can get a single 480mm radiator and direct mount it via the existing s19 120mm fan mounting holes and be good to go. For packaging reasons I've gone with two radiators and made it as complicated as possible.
Love it, I'll keep this in mind when I finally make the jump and but a miner
Nice! Also, would a setup that allows you to put your wet dishes into the heat stream, simulteanously cooling the miner and drying the dishes be feasible.
I think so, altough the only problem I see would be that the dishes have to little contact with the miner and thus cannot bring over the coldness to the miner.
