Did you do the soldering yourself or was the Pi pre-soldered?
Still can’t figure out why my nostr:npub17tyke9lkgxd98ruyeul6wt3pj3s9uxzgp9hxu5tsenjmweue6sqq4y3mgl won’t power on. 🤔
Very slight bend in the gpio connector pins but they still connect, not sure if that would be enough of an issue.
I have the proper power supply, SD card was brand new and flashed with the proper img file using Balena Etcher, and I’m pretty sure my soldering is fine.
Is there any way to test if my board or screen are faulty? I don’t know what else it could be, unless it is just the pins.
#bitcoin #asknostr #seedsigner 
Discussion
Myself! Not super clean but I /think/ it’s ok? Unless the solder can’t touch multiple pins in which case.. 
Yes, that's definitely your problem -- you have significant bridging that is likely causing the screen to not work and needs to be resolved. Removing some of the solder if you're able would probably be a good idea.
Thank you, I’ll give this a shot in the next couple days and report back!