Replying to LuisSP

reduced to 4 relays. faster.

but still a lot of "RECOMPUTING", around tens of seconds to a few minutes to load a thread/previous post. I mostly give up.

after 30 min online, it becomes faster to load threads/previous posts, but not always..

it is not just a internet issue because image fetches are fast (a few seconds at most), I never leave them on auto, always click when I want to see them

I know asking is easy and you are a lone developer.. but..

separate tabs for each request with specific status/icon messages for each one would be the best.

Or at least some queue drawing or general statistics to give me an ideia if I should give up, get a cup of tea, etc.

just a single status message on the bottom left is confusing, I forget to clik on it and it is not clear to which request it is refering to.

I am in South America using Free VPN hosted in Europe or USA.
Avatar
Mike Dilger ☑️ 2y ago

I've put some work into performance improvements on the lmdb branch. I will stabilize the format soon. If you try it now, you will have to wipe the lmdb driectory and reimport again later.

I also added a status bar to the bottom that shows the total number of events, and the HTTP activity (in flight / total being sought). That helps a bit to see what is going on... if your event count is climbing, then it's bogged down processing incoming events. That is common when you first startup after a long period and there are lots of events to catch up on. If the HTTP count is very high, then it's pulling down lots of images. I should also add relay count I guess.

You might also want to set your FPS to around 5. Maybe 10 if it can handle it. Don't try to run a high FPS. I may change settings to cap FPS at 30 instead of 60. I've been using 10 for a long time and it's smooth enough for me.

Reply to this note

Please Login to reply.

Discussion

No replies yet.