So now the big printer is coming to my place
Tired of this not printing well
She will bend the knee to my will
Discussion
Printer as a hobby not printer for another hobby. I borked mine last night trying to upgrade from a pi3b to a pi4b. Now I can't connect to printer from either. Looking like I'm going to need to reflash klipper from DTU mode to get working again.
At least that is where I gave up last night hours past my bedtime.
Always backup your configs
This helps when you need to reflash updated klipper
I have my configs. I seem to be unable to flash my new mcu id but it did wipe my old one. At least that is what I think is happening.
How are you flashing?
I tried the boot to a flashcard with nothing but firmware bin on the root method with no luck.
I am going to try DTU mode and make flash from the raspi next time I get a chance to work on it.
Yes DTU mode should work if SD card didn't
You may need to add jumpers per board you are using, to put in flash mode.
I spent all day trying to force DFU mode with no luck. I think maybe I borked it by loading STM firmware onto a GDM chip when I first flashed from my pi3b. Need to keep digging.
I ordered an st-link to try to recover and a new mobo in case that doesn't work. Going to solder a header onto the SWD pins while I wait on shipping.
Damn, best of luck to you
I considered alternate motherboards but I can't see why. What value would I get if I'm already running a 32bit microprocessor in the stock board?
Nothing it should be fine
Is this just a creality board?