My first try to install Umbrel did not work. I reformatted the sd card and tried again. I can see its IP but my browsers can’t connect to the server… 😔

Reply to this note

Please Login to reply.

Discussion

Are you trying to connect using local or tor ?

Local. I don’t know even if the connected HDD is working or not…😅 it feels awfully quiet.

😂😂 Good luck with that !

Thanks! This is supposed to be easy but no 😂

Yeah 😂 on my part when I installed Umbrel on my laptop it was smooth, for everything but never managed to connect my devices to Tailscale

Nice! It’s said Umbrel is easy when it works 😌

It will work eventually ! I’m sure !

Oh I hope everything would be fine 🥺

It’s okay. Just it’s hard to know what’s causing the problem…

😊💜

Can anyone help ? Kate is trying to run Umbrel on a Raspberry Pi

#[0]

Checking SD card is in fully - may sound silly but u’ll be surprised

It “clicks” in

And after that

Umbrel.local will show up

Thanks!

I tested another sd card with different OS and that worked but not umbrel somehow.

😳 this is a rasp pi?

Try different browser (safari instead of chrome, etc), try opening in incognito. Try putting the IP address directly into address bar (e.g. http://192.168.1.199/ ) and expand the bottom "it's ok to proceed to unsafe" dialog in the browser error page (if it's there). Try http://umbrel/ (without local)

Thanks for your help! Will try again.

www.mynodebtc.com

#MyNode

Thanks for the link :)

Do you have Umbrel connected to a router or switch that’s different than the WiFi router your browser is using? Confirm you’re to connect to the same switch.

Thanks for your help. I will change the connection directly to the router to see if it works! My hdd may have some issues.