I am quite impressed with Polymaker's PolyMax PC. Unlike the PolyLite PC (which is finicky as hell and basically not printable without an enclosure), PolyMax PC can be printed un-enclosed. It also flows better, warps considerably less, and comes in a range of different colours. Definitely will use this one more.
#3DPrinting
nostr:npub12atwfrq4rfv7fqara6gzsgrgj7k8ngewzl5nzs46agwyxzh0e25qxlme5y
nostr:npub12atwfrq4rfv7fqara6gzsgrgj7k8ngewzl5nzs46agwyxzh0e25qxlme5y For reference, I needed to use a combination of Dimafix, maximum bed temp (100C) and a brim. However, I was _probably_ over-insuring: I suspect the brim isn't necessary, at least for the part I was printing (fan shroud for the KP3S Pro V2).
For the fan shroud in question, I definitely gain something over the original annealed PLA-CF one: original weighed 24g, this new one only 16g.
