I was welding many different thicknesses and adjusting according. The settings are just numbers and letters. Not much to translate unless you know this particular machine. But it's from HF so you might consider it garbage as well. I am learning a lot by trying things. Having fun.
Discussion
have *U* tried adjusting angle of approach & a light scratching start & then roll back if that makes sense. The Beave i agree with on good tools or sit. to avoid bad or frustration/ pow is the way imho though - have fun/****
I am having tons of fun. I enjoy learning a lot.
thicker stuff i would \/ groove/grind @ times if eze access to spot & surfacing more fresh surface to weld/*****2gether 1/4 in. or even sum 1/8 depending/set flat is easier than vert. or other approach ime
Thank you.
i had/have a lot of diff. clamps 4 welding also nostr:npub1mgvmt553uphdpxa9gk79xejq3hyzh2xfa8uh6vh236nq78mvh74q8tr9yd