Replying to Avatar n0>1

I was welding many different thicknesses and adjusting according. The settings are just numbers and letters. Not much to translate unless you know this particular machine. But it's from HF so you might consider it garbage as well. I am learning a lot by trying things. Having fun.
da
Rand 9mo ago

have *U* tried adjusting angle of approach & a light scratching start & then roll back if that makes sense. The Beave i agree with on good tools or sit. to avoid bad or frustration/ pow is the way imho though - have fun/****

Reply to this note

Please Login to reply.

Discussion

Avatar
n0>1 9mo ago

I am having tons of fun. I enjoy learning a lot.

da
Rand 9mo ago

thicker stuff i would \/ groove/grind @ times if eze access to spot & surfacing more fresh surface to weld/*****2gether 1/4 in. or even sum 1/8 depending/set flat is easier than vert. or other approach ime

Avatar
n0>1 9mo ago

Thank you.

da
Rand 9mo ago

my pleze friend & anytime/build'r fab. most thingz from below ground uP*****

da
Rand 9mo ago

i had/have a lot of diff. clamps 4 welding also nostr:npub1mgvmt553uphdpxa9gk79xejq3hyzh2xfa8uh6vh236nq78mvh74q8tr9yd

da
Rand 9mo ago

^/ this is until *U* get moar accustomED 2 it

da
Rand 9mo ago

longweldz should spotweld @ pointz to hold distortion down then backfill/