Replying to Avatar PeakyBTC

3D printer help. First print attempt. Bed level stripes test

Ender 3 - V2 with auto leveler installed

Doesn’t seem right. What’s the issue? https://video.nostr.build/1a5f1d3ca1fdccea6bc8ae0591beb76f8283b9e59891e54701400be4bef679fa.mp4

Avatar
The Beave 2y ago

What's your z-height offset set to in the firmware?

Reply to this note

Please Login to reply.

Discussion

Avatar
PeakyBTC 2y ago

-.2. But I think I need to lower it down to the bed more

Avatar
The Beave 2y ago

Did you run the bed leveling procedure after the bed got up to temp?

Avatar
PeakyBTC 2y ago

No I didn’t. Will try that next

Avatar
The Beave 2y ago

I tend to let the bed soak for a long while before leveling.

Avatar
PeakyBTC 2y ago

Do you have an Ender? What do you keep the bed temp at? It defaults at 50. But feels like it should be higher.

Avatar
The Beave 2y ago

No, but I've printed a lot on various printers. Bed temp depends on material and ambient temps.