I like Go's approach. It is similar to what I will be doing with my compilers package manager `tpkg`
Been working hard this evening on the tutorial for setting up an RNode
#rnode #esp32
Libpurple plugin for Meshtastic? Very cool
Good stuff Bianca
(BTW can you see this reply, unsure if my DMs are reaching you)
RNodeInterface configured on Reticulum
#reticulum #rnode 
I wish whoever made the graph did a `dropNA()` on the portion where it had no data
USS Liberty
Oooh! Thanks for explaining!
?_nc_cat=109&ccb=1-7&_nc_sid=86c6b0&_nc_ohc=MJgwcF3HBpcQ7kNvgHO3a2J&_nc_zt=23&_nc_ht=scontent.fscl11-2.fna&_nc_gid=ATcmDdKPbXDnAyj4YXECWQ9&oh=00_AYAvBiDsl-FQ346lzdxRQMnQCd5s2BsP6nKkf8z7AodZww&oe=675B0D93Is that original sushi? Putting cream cheese in it?
I'd say look into OpenWRT as a base firmware and look at their hardware support list. I believe GLInet makes good products that they support.
Then you can go crazy with that and get things like batman-adv running over 802.11s
So this is LoRa transmitter. Runs on 868Mhz, has a much lower bitrate. Like very much lower.
Had to enable the "BLE option" as my device wasn't connecting without it. Seems the Lillygo T3-S3 is a Bluetooth low-energy device h which makes sense in any case.
#reticulum #lillygo #ble 
No problem. You'd have to somehow decouple ZigBee as a physical protocol to the actual ZigBee traffic itself and push that over IP somehow and then on the other end push it to the devices out of a zignee USB adatptor or something.
Mocking.
https://www.printables.com/model/741974-h1-case-for-heltec-v3-running-meshtastic
Those cases in the picture were modified a bit, but this is the case.
Thanks!
So the RNode firmware has a mode you can configure it for which lets you create a network interface on a UNIX machine that tunnels between both.
Maybe you could encapsulate some ZigBee traffic OVER such a link like that?